SecurityMan FlashDVR User Manual

Page 16

comparison to the day time use. The internal rechargeable battery of the Flash-

DVR in night time recording can last up to 4.5 hours (DVR on, Flashlight on).

To record at night time determine the use of audio (cover the mic port with the

rubber plug to mute or vice versa), position the camera at a desire angle, press

the Flashlight button to turn on the flashlight and then press the Record/Stop

button once to start recording. Night time recording visibility is limited to about

16~20 feet, environment may vary. Press the Record/Stop button again to stop

recording.

Underwater recording

There are several preparation steps to prepare before submerging FlashDVR

underwater for recording. To record underwater, please follow these steps:

1. Remove the waterproof plug from the back of FlashDVR by turning it counter

clockwise.
2. Switch the Main LOCK/ON/OFF Switch to the ON position. Turn ON the

flashlight if it is dark or leave the flashlight turn OFF if there is enough lighting

in the environment.
3. Press the Record/Stop button to start recording.
4. In order to avoid the impact of pressure on the buttons, the DVR has to be

in LOCK mode. Switch the Main Switch to the LOCK mode; this can be

accomplished by sliding the Main LOCK/ON/OFF Switch to the LOCK position.

Screw on the waterproof plug securely will prevent water from getting inside

to the Main Switch. In LOCK mode, everything is locked, including all the

buttons control.
5. Finally, to avoid the flow of water from damaging the microphone, please

make sure the microphone port is sealed with the waterproof rubber plug

located near the LED light.
6. FlashDVR is now safe to submerge underwater for recording and exploring.