SecurityMan FlashDVR User Manual

Page 13

To mount the adventure hat bracket to an object, helmet or wrist, place the Flash-

light DVR into the smoked plastic ring coupler holder, adjust DVR to a desire

position and then secure it down by fastening the latch. Next, loop and wrap the

elastic rubber strap around an object, helmet or wrist, thread elastic rubber strap

through the smoked plastic holder, and then secure by placing the plastic notch

through the belt hole of the rubber strap and thread the rubber strap through the

rubber holder. Lift up the rubber strap from the plastic notch to release the strap.

To mount the bicycle bracket to a handlebar or bar, place the Flashlight DVR in the

plastic holder (plastic notch towards the front of the DVR) and turn the thumb

screw clockwise to secure the DVR to the holder. Then mount the bracket to a

handlebar/bar and secure the bracket to the handlebar/bar by turning the thumb

screw clockwise. Turn the thumb screw counter clockwise to loosen the bracket.

Note: For handlebar/bar that is smaller than the bracket, use the adhesive

3M sticker on the inside of the bracket before securing. Measure the amount

of adhesive needed, cut adhesive according to measurement and then stick

it on the inside of the bracket.

To connect the lanyard to FlashDVR, simply hook the lanyard to the Waterproof

Plug of flashlight DVR and adjust the size by press+hold the leverage ball then

pull on the lanyard to adjust to the desire size.