SecurityMan DVR-04 - Manual (Page 13)

13
5.15 Motion setup
The first step is to setup video record method by Motion Triggered. Please refer back to 5.7 Record
Schedule.
After the “MOTION SET” step is completed, press “ Menu” to exit, and press [ Record ]
to start the Motion Record feature.
5.16 NTSC/PAL Output Select
Before turning on the DVR, make sure the J10 jumper is on the NTSC setting (for U.S.A) or PAL set-
ting (for Europe).
5.17 Restart
There are two restart modes. First, use the Power Switch to restart the DVR;
second, press the PAUSE key continuously for 12 seconds, it will be hot restarted.
MOT LEVER:
User can press “ Select” to adjust sensitivity grade
of motion detection.
High(1----------10)Low
MOT REC TIME:
This number indicates the recording time duration
when motion is detected. Press “ Select” to set the
time.
Time Set:5sec~30sec
MOTION SET
MOT LEVEL 5
MOT REC TIME 25
DVR Setup