SecurityMan DVR-04 - Manual (Page 12)

12
5.14 Sensor Setup
• Push the UNLOCK BUTTON to insert or pull out the wire
• There are 3 different modes for sensor setting:
NOT INSTALLED, NORMAL-CLOSE and NORMAL-OPEN.
It depends on what type of external sensor you use. If sensor’s output is NORMAL-OPEN then
select NORMAL-OPEN mode in DVR sensor setup.
If the sensor is triggered by an intruder then the cable line is connected to the DVR input terminal
will notify the system to start recording.
There are four pairs of input terminal.
Install example diagram:
- +
Power
Power
PIR Sensor
DVR
Connect PIR
sensor NO/NC
output to DVR
input termminal.
(Max. 5V DC)
Alarm
Sensor Input 1
Sensor Input 2
Sensor Input 3
SENSOR ALARM
Sensor Input 4
Alarm Out
Unlock button
SENSOR RECORD TIME
This number indicates the recording duration after
the sensor is triggered.
ALARM OUT TIME
It controls how long (in seconds) the alarm sound
lasts after it is set off.
Value “00” will turn off the alarm output.
Select “Cont” will turn on alarm output until any key
on the DVR is pressed
SENSOR SETUP
SENSOR RECORD TIME 10
ALARM OUT TIME 05
CHANNEL~1 TYPE:NORMAL-OPEN
CHANNEL~2 TYPE:NORMAL-CLOSE
CHANNEL~3 NOT INSTALLED
CHANNEL~4 NOT INSTALLED
>
DVR Setup