Attach rear panel attach door, Final assembly – Salamander Designs Synergy System SB303C/B User Manual
Page 2
A
.
Insert Hardware
Combine the 1” threaded studs with the flat
nuts. Slide hardware into rear channel.
A
.
Attach Hinges to Door Frames
Insert the hinges into the corresponding holes
on the doors. Turn the screws 1/4 turn to the
right to lock hinges in place.
NOTE: Do not over
tighten or the hinge will break.
D
.
Door Pull
Screw the Door Pull into place.
B
.
Adjust Clearance
Doors should be 1/8” above the bottom shelf before
fully tightening hinges to post. Use the wrench thickness
as a guide for the bottom gap.
C
.
Rubber Stops
Attach
the rubber stops to the inside of the door frame where it
hits the shelf pegs when closing the door.
C
.
Secure Studs
Use the hex key to secure the all
studs to the posts.
B
.
Place Panel
Allow bottom studs to remain
loose at bottom of post. Align the
Spacer Tool at the top of the post,
then position top studs through the
small “Rear Panel” hole. Repeat this
step with the bottom studs aligning
the Tool along the bottom of post to
set spacing for cable passage.
1
2
3
4
5
6
7
8
9
S20 /
SVDO
REAR P
ANEL
41/2"
6"
8"
www
.salamanderdesigns.com
EXTE
NDED
REAR P
ANEL
S30
/ S40
REAR P
ANEL
SP
ACER
TOOL
1
2
3
4
5
6
7
8
9
S20 /
SVDO
REAR P
ANEL
41/2"
6"
8"
ww
w.
salamanderdesigns.com
EXTE
NDED
REAR P
ANEL
S30
/ S40
REAR P
ANEL
SP
ACER
TOOL
2X
2X
REAR
1
2
3
4
5
6
7
8
9
S2
0 /
SV
DO
REA
R P
ANE
L
4
1/2
"
6"
8"
www
.salamanderdesigns.com
E
XTE
NDE
D
REA
R P
ANE
L
S
30
/ S
40
REA
R P
ANE
L
SP
ACER
TOOL
Attach Rear Panel
Attach Door
C
.
Insert Side Panels
Carefully slide side panels down center
channel of outside post. Be sure the
posts are square to the bottom shelf to
prevent any damage to side panels.
D
.
Secure Rear & Top
Put the remaining thumb nuts on
to complete panel installation.
B
.
Fine Tuning
Use the bubble level to precisely adjust
the shelves. Be sure to level both sides
as well as front to back. Use the hex key
to tighten each peg.
A
.
Placing & Adjusting Shelves
Place shelves from the bottom up. Angle the
shelf in between the front post and set on top of
shelf pegs. Use the Spacer Tool to adjust spac-
ing between shelves. Position the peg through
the Spacer and tighten.
5
Final Assembly
4
Note: The hinge can be separated by pulling the
black tab and pulling apart the hinge from the
hinge base. Separated hinges snap back together.
PULL
3
Rubber Tabs
A
B
SOFT CLOSE INSTALLATION
SLOW CLOSE
FAST CLOSE