Salamander Designs Synergy System SB402C/B - Manual (Page 3)

A
.
Attach Hinges to Door Frames
Insert the hinges into the corresponding holes on
the doors. Turn the screws 1/4 turn to the right to
lock hinges in place. NOTE: Do not over tighten
or the hinge will break.
D
.
Door Pull
Screw the Door Pull into place.
B
.
Adjust Clearance
Doors should be 1/8” above the bottom shelf before
fully tightening hinges to post. Use the wrench thickness
as a guide for the bottom gap.
C
.
Rubber Stops
Attach the rubber stops to the inside of the door frame
where it hits the shelf pegs when closing the door.
Attach Door
Note: The hinge can be separated by pulling the
black tab and pulling apart the hinge from the
hinge base. Separated hinges snap back together.
PULL
3
Doc No. 500-650/v11.12 402 -3/4