RECON 264150 Backup Projector Lamps DIY - Manual (Page 6)

Page 6
Firewall & Use Sealed Grommets (Recommended). Or Find An Existing Hole To Run Your Wires.
•
Find The Location You Would Like To Mount Your Switch
• Wire Your Switch With The Remaining Part of The Harness Supplied With Your Recons. Wired Accordingly
** The Fused Power Wire Is Not The Power Wire Being Ran To Power The Reverse Projector Lights (This Should Be A 5 Amp
Fuse)
• It Is Required At This Time, To Decided Where To Mount The Relay. In This Install, I Chose The Drivers Side Panel On The Dash
- Which Will Simply Pop Off With A Small Screw Driver. The Relay Can Then Screw Onto The OEM Dash Screw.
You Are Now Ready To Wire The Relay - Wiring The Relay
- Start By Running The Wires Ran From The Rear, Up To The Open Panel In The Dash.
• Cut A Short Piece of Wire, Strip Both Ends - Install The 1N4005 Diode - With The Wire Ran From The OEM Reverse Lamps, -
***BE SURE TO INSTALL FACING THE PROPER WAY*** The Stripe On The Diode Should Be Facing The Rear Use Heat
Shrink To Protect The Diode