Archive, Aviator power unit - safety – Ransburg Aviator Power Supply Unit 75983-02 User Manual

Page 6

CP-97-01.1

AVIATOR Power Unit - Safety

A R E A

Tells where hazards

may occur.

H A Z A R D

Tells what the hazard is.

S A F E G U A R D S

Tells how to avoid the hazard.

Spray Area

Electrostatic Arcing

Ensure the Ground Wire Assembly is connected from
the power supply ground stud to a true earth ground.

Ensure that the power supply is plugged into a
properly grounded outlet.

If shocks or sparks are noticed at any point in the
spray system, immediately turn off the power supply
and check the complete system for the cause. DO
NOT use the system again until the problem has
beenidentified and corrected.

Never operate the applicator without properly grounding
the following:

A. Operators

Operators

Operators must be grounded. Rubber soled
insulating shoes should not be worn. Grounding
leg straps may be used.

Operators must maintain contact with the handle
of the applicator. If work gloves are used, the
palm section should be cut out.

Operators must remove from themselves all
metal objects that are not grounded.

NOTE: REFER TO NFPA-33 REGARDING

NOTE: REFER TO NFPA-33 REGARDING
OPERATOR GROUNDING.

OPERATOR GROUNDING.

B. Parts being sprayed. Resistance between the

part and a grounded conveyor must not exceed
1 megohm.

C. Every metal and conductive object in the spray

area. This includes the booth, parts hangers,
fire extinguishers, conductive flooring, etc.

Grounded conductive flooring must be provided in the
spray area.

Turn off voltage at the power supply before flushing
out, cleaning, or removing any parts from the
applicator.

Provide proper protection for waterborne supply
systems.

Never install a applicator into a fluid system using an
isolated solvent supply.

ARCHIVE