Ransburg Aviator Power Supply Unit 75983-02 - Manual (Page 14)

CP-97-01.1
INST INST INST INST INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
AVIATOR Power Unit - Installation
1 1 1 1 1 1 1 1 1 1
LOCA LOCA LOCA LOCA LOCATION / MOUNTING TION / MOUNTING TION / MOUNTING TION / MOUNTING TION / MOUNTING
The AVIATOR may be located within the hazardous
location. It may be mounted on a booth wall, pump
cart, or other suitable place.
The AVIATOR features a flexible mounting system
that allows either hard mounting of the unit, or
semi-removable mounting.
To mount the unit, anchor suitably into the booth
wall. The bolt pattern is indicated in Figure 2.
(Mount the bracket to the wall with appropriately
sized fasteners.)
Figure 2: Mounting Bolt Pattern Figure 2: Mounting Bolt Pattern Figure 2: Mounting Bolt Pattern Figure 2: Mounting Bolt Pattern Figure 2: Mounting Bolt Pattern
> The control unit MAY be located inside
the hazardous area. (See NFPA-33,
OSHA, and ITW Ransburg Bulletin: "Oper-
ating Your Electrostatic Coating System
Safely".)
> The user MUST MUST MUST MUST MUST read and be familiar
with the "Safety" section and safety precau-
tions in this manual.
> This manual MUST MUST MUST MUST MUST be read and thor-
oughly understood by ALL ALL ALL ALL ALL personnel who
operate, clean, or maintain this equipment!
Special care should be taken to ensure that
the warnings and requirements for operat-
ing and servicing safely are followed. The
user should be aware of and adhere to ALL
ALL ALL ALL ALL
local building and fire codes and ordi-
nances, as well as NFPA-33 and OSHA,
prior to installing, operating, and/or servic-
ing this equipment.
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G
!!!!!
> As each installation is unique, this infor-
mation is intended to provide general instal-
lation information for the AVIATOR control
unit. Consult your authorized ITW Ransburg
distributor for specific directions pertaining to
the installation of your equipment.
It is recommended that the AVIATOR be in-
stalled in a vertical position to give best per-
formance to the unit.
N O T E N O T E N O T E N O T E N O T E
> Do Not Do Not Do Not Do Not Do Not use the AVIATOR in environ-
ments above 110 o F.
C A U T I O N C A U T I O N C A U T I O N C A U T I O N C A U T I O N !!!!!
> The ground wire assembly MUST MUST MUST MUST MUST be
connected from the control unit ground stud
to a true earth ground.
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G !!!!!
ARCHIVE