Ransburg 9040 Classic HV Power Supply 76447 - Manual (Page 20)

CP-97-02.5
9040 Classic for REA & M90 Systems - Operation
1 7 1 7 1 7 1 7 1 7
OPERA OPERA OPERA OPERA OPERATION TION TION TION TION
Figure 6: Operating Controls Figure 6: Operating Controls Figure 6: Operating Controls Figure 6: Operating Controls Figure 6: Operating Controls
> The user MUST MUST MUST MUST MUST read and be familiar
with the Safety Precautions Safety Precautions Safety Precautions Safety Precautions Safety Precautions and
"Safety" Section "Safety" Section "Safety" Section "Safety" Section "Safety" Section in this manual and the
ITW Ransburg safety literature therein
identified BEFORE OPERATING
BEFORE OPERATING BEFORE OPERATING BEFORE OPERATING BEFORE OPERATING the
9040 Classic power supply.
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G !!!!!
> The electrical discharge, which is
available from the charging electrode of the
applicator, must not exceed 0.25 mJ of
energy. To achieve this limit, any flow of
energy from the paint supply through the
paint line to the applicator electrode MUST
MUST MUST MUST MUST
be prevented by grounding the paint line at
the applicator handle or body.
Verify that
the applicator is actually grounded BE- BE- BE- BE- BE-
FORE FORE FORE FORE FORE operating it! (See the appropriate
applicator manual.) If improper readings are
obtained, check that the power supply is
grounded. (See "Ground Test Procedure" in
the "Maintenance" section of this manual).
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G !!!!!
ARCHIVE