Ransburg Serial Node Adapter LECU4002_78553 - Manual (Page 37)

If the address 0 motherboard is a 78145-00, hav-
ing a Serial Node Adapter in the leftmost slot,
the procedure is the same. There is simply no
contribution to a configuration word from this slot
(Word 0, bits 12-15 are zero).
If any of the slots are empty, simply enter zero
for that slot.
With MicroPak
When a MicroPak is used, there is no change to
the configuration system. There is no configura-
tion word used for the MicroPak, but MicroPak
switch SW7 must be set at the default, address
1 (positions 1, 2, and 3 ON, position 4 OFF). In
the following example, a MicroPak motherboard
has been added to this combination.
The configuration words are identical to that above.
Note that at least one of the motherboards in this
example must be located in another physical rack.
The above examples show a maximum number
of modules communicating with one Serial Node
Adapter. A more practical system (single bell)
might be:
Serial Node Adapter/Serial Node Adapter + - Operation
Ransburg
33 LN-9238-02.3