Ransburg 9060 HV P.S. Air Motor 80102-31X - Manual (Page 17)

9060 for No. 2 Process Handgun - Introduction
CP-13-04.2 12
SIGNAL INTERFACE
The 9060 Controller, when configured for use
with the No. 2 Process Handgun, requires only
one signal input for operation, the trigger signal.
Trigger Signal
The trigger signal input (J3-5) for a No. 2
Process Handgun comes preconfigured as
a sinking input wired directly to the air flow
switch. Please refer to “Installation” section
of this service manual for more information.