LumaStream Trinity PERMANENT User Manual
Page 14

Document: 66APPMAN Rev: H
14 of 32
9.0 DIMMING CONTROL OPTIONS
Trinity LED Driver Dimmer is available with either DMX or 0-10V analog
control dimming options.
DMX control configurations follow the ESTA DMX-512A standard.
Specifications can be found in table 7 at the beginning of this manual.
Trinity LED Driver Dimmer DMX Installation information, typical wiring
diagrams etc. are found in section 10 of this manual.
Analog 0-10V control configurations follow both the IEC 60929 (AnnexE)
and ESTA E1.3-2001 standards. Specifications can be found in table 9 at
the beginning of this manual.
Trinity LED Driver Dimmer Analog installation information, typical wir-
ing diagrams etc. may be found in section 11 of this manual.
Trinity PC Multi-Zone Analog installation information may be found in
section 12 of this manual.
Document: 66APPMAN Rev: H
19 of 32
10.6 Output Channel Connections and DMX Address Mapping
DMX Address
Output
Channel
Belden/Alpha or
Equivalent Wire Color/
Polarity
Fixture #
Fixture LED
Color
Base Address (BA)
1
WHT + / BLK -
1
Blue
BA +1
2
RED
+ / BLK -
1
Red
BA+2
3
GREEN
+ / BLK -
1
Green
BA+3
4
WHT + / BLK -
2
Blue
BA+4
5
RED
+ / BLK -
2
Red
BA+5
6
GREEN
+ / BLK -
2
Green
BA+6
7
WHT + / BLK -
3
Blue
BA+7
8
RED
+ / BLK -
3
Red
BA+8
9
GREEN
+ / BLK -
3
Green
BA+9
10
WHT + / BLK -
4
Blue
BA +10
11
RED
+ / BLK -
4
Red
BA +11
12
GREEN
+ / BLK -
4
Green
The 3 position rotary switches sets the DMX address of the
TRINITY LED Driver Dimmer.
IMPORTANT: Each channel within the TRINITY DMX requires a DMX
address. The rotary switch address identifies the Base
Address (BA), which is output channel ‘1’. Output channel 2 will be
the next address (BA+1) and so on up to output channel 12 (BA + 11).
The TRINITY DMX will automatically detect a change in address in
less than 2 seconds. No recycling of the AC input is required to im-
plement a change in address location.
In the case of daisy chained TRINITY DMX units, only the last
unit in the chain is terminated by means of a 120 ohm +5%/-10%
impedance inserted into the DMX connector.
DMX Address
Output Channel
Belden/Alpha or Equivalent Wire Color/
Polarity
Base Address (BA)
1
WHT + /
GREEN
-
BA + 1
2
RED
+ / BLK -
BA + 2
3
WHT + /
GREEN
-
BA + 3
4
RED
+ / BLK -
BA + 4
5
WHT + /
GREEN
-
BA + 5
6
RED
+ / BLK -
6 Channel Units
12 & 9 Channel Units