Kasco Marine 4400EJ - Manual (Page 6)

6
against the fl oat and the 3 handles on the screen do not
interfere with the rope placements.
Fit the 3 Bottom
Screen cushions (Part M) underneath the screen and
on top of the 3 spacing bumps on the bottom of the
fl oat.
Bottom Screen cushion
Using a stainless steel Bottom Screen Clip (Part
H), 3/8”-16 x 1-3/8” Bolt (Part G), two 3/8” Flat
Washer (Part E), and 3/8”-16 Nylon Lock Nut
(Part F) to secure the screen to the fl oat. Align a
clip so the two prongs straddle a wire on the
screen. Insert bolt with washer so the top of the
bolt is facing the top of fl oat (now in down posi-
tion). Place the second washer and the locking nut
with nylon insert on the end of the bolt and tighten
using the 9/16” (14mm) Socket and Ratchet on the
nut end and the 9/16” (14mm) Wrench on the bolt
end. Tighten until snug and repeat with remaining
clip.
STEP SIX
Turn the assembly upright again. At this time,
if the cord contains a metal strain relief, you
can use the chain connector and attach it in
one of the opening at the rope placement. The
chain connector will easily fi t if installed from
the bottom or top side of the opening. It will
not fi t if installed from side of opening. Use
the Nylon Cable Tie (Part I) included to secure
the power cord to a molded hole in the fl oat to
prevent cord damage if there is no strain relief
on the cord. If a Strain Relief is present on the
cord, you may disregard the Nylon Tie. On
cords with a Quick Disconnect, the disconnect
should be tightened properly to avoid leaking.
If installing a new Quick Disconnect, refer to
Quick Disconnect Instructions. If ready to in-
stall in the pond, go to Installation instructions.
3400EJ, 4400EJ Parts
Aerating Fountain (Unit with cord or unit with 1.
Disconnect) (1)
Float (with two 50’ mooring ropes attached) (1)
2.
1/4-20 x 3 1/4” Phillips Pan Head Screw (4) 3.
1/4” split washers (4) 4.
1/4” (3/4” outer diameter) Flat Washer (4) 5.
3/8”-16 x 1-3/8” Hex Head Bolt (2) 6.
3/8” Flat Washer (4) 7.
Float Retaining Clips (4) 8.
Bottom Screen cushions (3) 9.
Bottom Screen (1) 10.
Bottom Screen Clips (2) 11.
3/8”-16 Nylon Lock Nut (2) 12.