Kasco Marine 2400SF xStream - Manual (Page 4)

4
6. Secure the 3 sections of the screen together in 6 places
using #8 screw, #8 lock washer, two #8 flat washers, and
#8 nut. Do not overtighten. Alternately, use cable ties
instead of hardware for a quicker assembly of the screen.
#8 screw
#8 lock washer
#8 flat washer
#8 nut
For quicker assembly:
Use cable tie instead
#8 screw
#8 lock washer
#8 flat washer
#8 nut
For quicker assembly:
Use cable tie instead
Assembly
1. Make sure you have all the parts needed. If any
shortages are found, contact your Kasco representative
immediately.
2. Place float on motor housing. The power cord notch on
the float should line up with the cord. See diagram below
of bottom side of float. The 3 bolt holes in the float should
line up with bolt receptacles on unit.
power cord notch
3. Use one of the 1/4”-20 x 3-1/4” Phillips Pan Head
Screws, one 1/4” split washer, and a 1/4” Flat Washer to
secure the float. Make sure the split washer goes between
the bolt head and the flat washer. Insert screw with washers
through bolt hole in float. Tighten until snug with a Phillips
Head screw driver and repeat for 2 remaining screws.
4. Set motor housing and float upside down on a flat
surface.
5. Bring the 3 bottom screen sections together.