Hauler Racks SERVICE BODY ‘C’ MOUNT RACKS - Manual (Page 2)

1. Connect front and rear sections
Each side rail side contains a front and rear section preassembled for easier assembly. The front and
rear sections are banded together.
Remove the banding and separate the front and rear rail sections from packaging.
On a flat surface, place boards under the front and rear rail sections as shown so that the rear ‘H’
bracket does not touch the ground. This will make aligning the front and rear rail sections faster.
On the front section (the end with the straight round tube), slide the 5” bracket backwards until the two
back holes on the 5” bracket line up with the two holes on the end of the lower rectangle tube.
Insert the rear rail section into the 5” bracket and line up with two remaining holes.
HAULER RACKS, INC. Toll Free: 1-800-843-5445
7109 31 st Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
Page 2 of 15 WWW.HAULERRACKS.COM