General Tools and Instruments WDCFM8912 User Manual
Page 4

3. ENTER:
- To confirm the setting & calibration.
4. Mx/Mn/Up
L
Mx/Mn
:
- Pressing to view MAX/MIN/AVG value.
- Press to select the value of each digit in cycle.
5. REC/START:
- To start measuring volume or capacity without waiting.
6. HOLD/Down
L
HOLD
:
- In basic modes pressing this key to hold the current reading,
then pressing this key again to unlock the holding.
- Pressing to select the setting digit.
7. Power +
L
Mx/Mn
:
- When the meter is off, pressing more than two sec. to enter
non-sleep mode.
8. Power +
L
Mx/Mn
+
M
HOLD
:
- Pressing more than two seconds to enter RH calibration mode.
9. ENTER +
L
HOLD
:
- Pressing to turn on/off the backlight.
POWER ON/OFF & UNIT SELECTION
Press
O
to turn on the meter with auto-sleep mode. Press again
to turn off the meter at any mode.
When the meter is off, pressing
O
more than two seconds to enter
units selection mode.
When in unit selection mode, press
L
Mx/Mn
or
M
HOLD
to select the
unit then, press
ENTER
to save and meter will be powered on
automatically.
4
WDCFM8912 Manual final2F-062708:Layout 1 6/27/08 10:55 AM Page 4