General Tools and Instruments DCS100 - Manual (Page 8)

INSTALL THE SOFTWARE
1. Place the installation disk CD in your computer’s CD/DVD drive and
close the drawer. After the CD loads, the “Welcome to the Scope
View Setup Wizard” screen will appear. Click Next to continue.
(Using the ScopeView Setup Wizard)
In addition to installing the ScopeView application,
you can also use the ScopeView Setup Wizard to:
• Remove ScopeView from your computer.
• Repair errors in the most recent installation by fixing
missing and corrupt files, shortcuts and registry entries
• Change the way features are installed.
To perform any of these tasks, place the installation disk in
your CD/DVD drive and close the drawer. You can also uninstall
ScopeView by following the path “Start”->”All Programs”-
>”ScopeView”-> “Uninstall ScopeView” and clicking “Enter”
to confirm the uninstall.)
2. Read the End-User License Agreement and accept its terms by
checking the box at lower left and clicking Next.
3. On the Custom Setup screen that appears next, note the advisory
that ScopeView will be installed in the ProgramFiles folder of your
computer’s C drive by default. This is the recommended location.
Unless you want ScopeView to be installed elsewhere on your
computer, click Next.
4. On the screen that appears next, click Install to begin the
installation.
5. The next screen that appears is a Windows User Account Control
dialog box. Respond to the question, “Do you want to allow the
following program from an unknown publisher to make changes to
your computer?” by clicking “Yes”.
6. When the notification, “Completed the ScopeView Setup Wizard”
appears, click Finish.
8