Fairbanks IM 6000 Series In-Motion Scale System with FB3000 User Manual
Page 9
50792
9
05/05 Issue #1
Enter
Used to store selections into memory during programming. The scale can be setup to
operate in one of two modes: GROSS, TARE, NET weighing and IN/OUT weighing.
Lamps
Green
The On scanner has detected a box being on the scale.
Red
The Off scanner has detected a box exiting the scale.
f1
Save As - Saves data file to your designated file name and location.
f2
Sample or Trace - Samples weight on the platform or traces box from on to off scanners.
f3 Timed Dependancy Test - Performs a one (1) hour test of weights captured.
f4
Start - Time Dependancy Test Start which can vary by entering duration time.
f5
Stop - Time Dependancy Test End which will manually stop any test.
f6
View - Allows viewing of records of a test which was performed. Pressing the F6 a sec-
ond time allows viewing of A/D counts from the PC104 card.
B.
General Programming Instructions
The programming menus that contain all of the parameters for the system are listed below.
1. Options Menu - Accessible without a password by pressing the MENU key. This menu is
used for general weighing operations and accessing further programming menus.
2. Configuration Menu - This menu is used to enter the parameters for the Keyboard Tare,
AutoTare, Select Scale, Format Ticket, and view the Load Cell Diagnostics. These adjust-
ments are made by authorized personnel only and is password protected.
3. Service Menu - This menu is used to program the technical parameters of the system,
such as scale capacity, span, and load cell data. These adjustments are made by autho-
rized personnel onlyand is password protected.
4. The following instructions apply to all of the menus.
a. In all menus, the UP or DOWN arrows move the cursor in the indicated direction.
b. To make an entry, place the cursor beside the item to be selected and press the ENTER
key. The operator will be prompted for the data to be entered.
c. A Enter Password prompt means the menu item is locked and can only be accessed
with a password.
d. Data may be entered through the keypad.
e. When the appropriate data has been entered, press the ENTER key to record the data into
memory.
f, Data may also be selected by pressing the right arrow key to toggle to the appropriate
value.