Fairbanks Aegis Drum Scales - Manual (Page 15)

Section 2: Scale Installation
04/10 15 51190 Rev. 2
2.2.2. Wheel Kit Assembly Steps
1. Unpack the Wheel Kit.
─ Inspect it thoroughly for any obvious shipping or
handling damages.
2. Stand the Instrument Pillar onto the Wheel Kit
Assembly.
3. Fasten the Pillar to the Platform with the three (3)
5/16 ” bolts and lock washers.
4. Place the Instrument Stand on the Pillar.
5. Rotate the Instrument Stand to its desired position.
6. Screw in, but do not tighten completely, the three (3) ¼” Allen Screws on
the collar of the Instrument Stand.
7. Place the Aegis Drum Scale into the Wheel Kit Assembly.
─ Use Eye Bolts for ease of installation.
─ The area in the Drum Scale where the Interface Cable exits should face the
pillar.
8. Route the Platform Interface Cable up
through the pillar to a second hole, just
under the Indicator Stand.
9. Feed the cable through the final bushing,
leaving enough cable to connect it to the
Instrument.
10. Tighten the three set screws to secure the
top plate to the pillar.
W A T C H Y O U R F I N G E R S !
Fingers can be pinched when placing the Scale into the
Wheel Kit Assembly, especially in the corners.
W A R N I N G !