Earthway C25HDS Stainless Steel Professional Tow Broadcast Spreader - Manual (Page 4)

PAGE 4
The settings furnished on the Rate Setting Matrix are intended as a guide only. Variations in physical characteristics of
material applied, tow speed, and roughness of ground surface may require slightly different spreader settings. Due to the above
conditions, the manufacturer makes no warranty as to the uniformity of coverage actually obtained from the settings listed.
5-YEAR LIMITED WARRANTY
Earthway Products, Inc. warrants this product to be free of defects in original workmanship and materials for a period of
5-Years to the end user with the original purchase receipt. If a manufacturing non-conformance is found, Earthway Products,
Inc. at its discretion will repair or replace the part(s) or product at no charge provided the failure is not the result of incorrect
installation, mishandling, misuse, tampering, or normal wear and tear as determined by Earthway . Earthway at its discretion
may require that the part(s) or product be returned along with the original purchase receipt at owners’ expense for examination
and compliance with the terms of this warranty. Do not return any product without first receiving authorization from Earthway
Products, Inc. To seek remedy under this warranty, contact Earthway Products, Inc. at 574-848-7491, techsupport@earthway
.com or write to Earthway Products, Inc. P.O. Box 547 Bristol, Indiana 46507 and describe the nature of the manufacturing
defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor charges associated with
repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of most fertilizers and ice
melt products, Earthway Products, Inc. makes no warranty against and specifically excludes part(s) or product degradation or
failure due to corrosion or its effects. Clean and dry your spreader thoroughly after each use, as a preventative measure, coat
all metal parts (inside the tubing especially) with a light oil or silicon spray.
HOW TO ORDER SPARE PARTS
All spare parts listed herein may be ordered direct from the manufacturer. Be sure to give the following information when
ordering.
; m
odel
n
umber
; p
Art
n
umber
; p
Art
d
eSCription
If you have any questions please send an email to [email protected], or call (574) 848-7491 or 800-294-0671 to place an
order using your credit card.
OPERATING INSTRUCTIONS
Before filling hopper, become familiar with the operation of this spreader.
1. Obtain proper setting for material to be used from the RATE SETTING CHART included with this spreader.
2. Move stop bolt on rate gauge assembly to the proper setting.
3. While pushing spreader forward, pull control lever back to stop bolt.
4. To stop, push lever forward to close flow holes before you stop moving.
5. When finished, empty any remaining material from hopper.
6. Thoroughly wash spreader and allow to dry before storing. Light oiling can prevent corrosion.
Full Rate Path Half Rate Path
Start
Finish
Start
Finish