Earthway 2130SS Commerical HIGH-OUTPUT Broadcast Spreader User Manual
2130ss, High-output b, Assembly and operating instructions
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
THIS SPREADER COMES PARTIALLY ASSEMBLED, REQUIRING YOU TO INSTALL THE WHEELS, HANDLE ASSEMBLY AND
CONTROL ROD. IT SHOULD TAKE APPROXIMATELY 10 MINUTES WITH THE USE OF TWO 7/16” WRENCHES AND 1 PAIR
OF PLIERS.
;
Clean the impeller plate after each use. Material build up on the impeller blades will cause uneven spreading.
;
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
will change the spread patterns. Wet material will also change the spread pattern and flow rate.
;
Clean your spreader thoroughly after each use. Wash between the shut off plate and bottom of the hopper.
;
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
;
When using Rock Salt remove salt from the hopper daily. Rock Salt will reconstitute back into a solid block over night
with humidity. As a preventative measure, spray all metal parts thoroughly (inside the tubing too) with a spray oil to
prevent corrosion on painted chassis models.
1. Open carton and remove the handle assembly, wheels, and spreader from
carton.
2. Turn spreader upside-down on to the hopper.
8-2013 Pt.# 53107ss
PAGE 1
2130SS
HIGH-OUTPUT
B
roadcast
s
preader
ASSEMBLY and OPERATING INSTRUCTIONS
SLIDE
Gearbox &
Axle Assembly
Lower
Handle
Frame
Brace
Cross Brace
Axle Bushing
3. Ensure that the axle bearings are pushed into the axle
bushing on both sides as shown. Install drive wheel (both
wheels are interchangeable) to axle using pin hole nearest to
lower handles as shown. Insert 2” cotter pin through wheel
and through axle. Bend with pliers to prevent pin from falling out.
4. Install coast wheel to axle, then using outside pin hole as shown, insert 1” cotter
pin through axle (not thru the wheel). Bend with pliers to prevent pin from falling
out.
2” Cotter Pin
1” Cotter Pin
Coast Wheel
Drive Wheel
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,
:
techsupport
@
earthway
.
com