beautypg.com

Earthway C24HDS Stainless Steel Professional 100lb/45kg Broadcast Spreader User Manual

C24hd & c24hds, Warning, Helpful hints

background image

C24HD & C24HDS

Broadcast Spreader

Assembly and Operating Instructions

36210

Qty 2

36214

Qty 4

36200

Qty 4

36205

Qty 3

36300

Qty 17

36207

Qty 2

36305

Qty 2

33117

Qty 1

36105

Qty 1

36104

Qty 1

36103

Qty 1

36209

Qty 4

36404

Qty 18

vvvvvvvv

vvvvvvvv

Upper Handle

Gauge & Lever

Handle

Shaft

Frame

Brace

Cross

Brace

Lower

Handles

Impeller

Frame

Gearbox

Pivot

Control

Rod

Pivot

Rod

(Qty 4 #36214)

1/4-20 X 1½”

Phillips Panhead

(Qty 4 #36300)

1/4-20 SS Locknut

2. Position hopper on side. Install frame using (4) 1/4-20 x 1 ½” Pan Head Phillips

machine screws and (4) 1/4-20 nylon insert locknuts. First put bolts through holes

in frame then through holes in bottom of hopper. Secure with locknuts. TIGHTEN

THESE LOCKNUTS NOW.

1. Remove and identify all of the loose parts from carton.

1-2012 Pt# 52142 PAGE 1

Gauge Overlay is snapped over

the metal gauge. Replace the stop

bolt assembly to secure overlay on

the gauge.

WARNING

DO NOT USE AIR TOOLS TO ASSEMBLE. TO PREVENT

SEIZING SPRAY ALL NUTS & BOLTS WITH FURNITURE

POLISH OR WAX

PLEASE CONTACT US: IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY

QUESTIONS REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL

SUPPORT. SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: [email protected]

HELPFUL HINTS:

;

If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must

turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller after each use as some

fertilizer may become stuck on the impeller blades and will cause uneven spreading.

;

Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change

the spread patterns. Wet fertilizer will also change the spread pattern and flow rate.

;

Clean and dry your spreader thoroughly after each use, wash between the shut-off plate and bottom of the hopper regularly. To

prevent rust, coat all metal parts (inside and out) including the frame tubes with a light oil or silicon spray.

;

Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.

;

If you use Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock Salt will

reconstitute back into a solid block if left in the hopper overnight and will damage your gearbox if pushed with the block in place.

ROCK SALT AND POWDERED MATERIALS SHOULD

NOT BE USED IN THIS SPREADER AS IT WILL DAMAGE

GEARBOX AND CAN VOID WARRANTY.

USE ONLY GRANULAR MATERIALS.

IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7

This manual is related to the following products: