Earthway C25HDS Stainless Steel Professional Tow Broadcast Spreader - Manual

Your spreader is shipped semi assembled, you will need (2) 7/16” wrenches, a cutting tool to cut through the plastic zip-ties,
and a pair of pliers to bend the cotter pins that hold the wheels to the axle.
1. Remove the spreader and identify all loose parts from carton.
2. Remove the Zip-ties holding the C
ontrol
S
upport
A
SSembly
to the C
roSS
b
rACe
and the 2 bolts that are in the frame
12-2011 Pt# 52155 PAGE 1
C25 S
erieS
p
rofeSSionAl
t
ow
b
roAdCASt
S
preAder
ASSEMBLY and OPERATING INSTRUCTIONS
EV-N-SPRED EV-N-SPRED
EarthWay EarthWay
R R
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,
emAil
:
teChSupport
@
eArthwAy
.
Com
HELPFUL HINTS:
READ THE DIRECTIONS BEFORE ASSEMBLY
; If your spreader does not spread evenly, be sure the FRONT on the gear box points away from the tow bar of the spreader.
The impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the
impeller plate after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pulled at three miles per hour, which is a brisk walking speed. Slower or faster speeds will
change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader
thoroughly after each use. A coating of light spray oil on all metal parts, (including the inside of the frame tubing) will help
prevent corrosion. Wash between the shut off plate and bottom of the hopper.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
OVER
3 MPH
Do not tow
faster than
3 MPH
ROCK SALT and POWDERED MATERIALS
should not be used in this spreader as it will
damage gearbox and can void warranty.
Use only granular materials.
Remove
Zip-ties
Remove
¼-20 x 2¼” Bolts
washers & lock nuts
#40003
Screen
#19117 Wheels
#36103
1” Cotter Pin
#36104
2” Cotter Pin
Hitch
Assembly
#42251 Clevis Pin
#36108 Hair Pin Clip
Control Support
Assembly