Earthway 2150 Commercial Broadcast Spreader - Manual

31104
Qty 4
32100
Qty 2
33117
Qty 1
36105
Qty 1
31100
Qty 4
31120
Qty 5
32103
Qty 9
31106
Qty 2
33108
Qty 1
33109
Qty 1
12152
Qty 2
12148
Qty 2
vvvvvvvv vvvvvvvv
13
16
17
31
24
28
23
25
26
9
11
12
1. Remove and identify all loose parts from carton .
(Qty 4) #31104
#14 X 1-1/2”
Flat Head Screw
2. Position hopper on side. Install frame using (4) #14 x 1½” Flat Head Phillips
screws. TIGHTEN THESE NOW
12-2011 Pt# 52157 PAGE 1
2150 C
ommerCial
B
roadCast
s
preader
ASSEMBLY and OPERATING INSTRUCTIONS
EV-N-SPRED EV-N-SPRED
EarthWay EarthWay
R R
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,
email
:
teChsupport
@
earthway
.
Com
SKYPE: EARTHWAY.TECH
HELPFUL HINTS:
READ THE DIRECTIONS BEFORE ASSEMBLY
; If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The
impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller
plate after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
will change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your
spreader thoroughly after each use. A coating of light spray oil on all metal parts inside & out will help prevent corrosion.
Wash between the shut off plate and bottom of the hopper. Do not use powdered materials.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
ROCK SALT and POWDERED
MATERIALS should not be used in this
spreader as it will damage the gearbox and
can void the warranty.
Use only granular materials.