Earthway 2170PRO Commercial/Professional Broadcast Spreader User Manual
Earthway, 2170p, Roadcast
36210
Qty 2
36214
Qty 4
36200
Qty 4
36216
Qty 5
36205
Qty 2
32100
Qty 2
33117
Qty 1
36105
Qty 1
36104
Qty 1
36103
Qty 1
36300
Qty 6
12152
Qty 2
12148
Qty 2
vvvvvvvv
vvvvvvvv
13
16
17
31
24
28
23
25
26
9
11
12
1. Remove and identify all loose parts from carton
.
(Qty 4 #36214)
1/4-20 X 1½”
Phillips Panhead
(Qty 4 #36300)
1/4-20 SS Locknut
2. Position hopper on side. Install frame using (4) 1/4-20 x 1-1/2” Pan Head
Phillips bolts and (4) 1/4-20 nylon insert locknuts. First put bolts through
holes in frame then through holes in bottom of hopper. Secure with locknuts.
TIGHTEN THESE LOCKNUTS NOW
DO NOT TIGHTEN WITH POWER TOOLS
1-2012 Pt# 52166
PAGE 1
2170P
ro
B
roadcast
s
Preader
ASSEMBLY and OPERATING INSTRUCTIONS
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,
:
techsuPPort
@
earthway
.
com
SKYPE: EARTHWAY.TECH
EV-N-SPRED
EV-N-SPRED
EarthWay
EarthWay
R
R
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7
HELPFUL HINTS:
;
If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller after each use as some
fertilizer may become stuck on the impeller blades and will cause uneven spreading.
;
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader thoroughly after each
use. To prevent rust, please coat all metal surfaces, also inside tubes where possible, with a light oil or WD-40. Wash between the shut
off plate and bottom of the hopper.
;
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
;
If you must use Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock Salt
will reconstitute back into a solid block over night with humidity and will damage your spreader.
ROCK SALT and POWDERED
MATERIALS should not be used in this
spreader as it will damage gearbox and can
void warranty.
Use only granular materials.