Earthway 2150T Commercial Tow Broadcast Spreader - Manual

(Qty 4) #31104
#14 X 1-1/2”
Flat Head Screw
12152
Qty 2
12148
Qty 2
31104
Qty 4
32100
Qty 2
33117
Qty 1
36105
Qty 1
31100
Qty 7
31114
Qty 3
32103
Qty 10
31106
Qty 3
33108
Qty 1
33109
Qty 1
vvvvvvvv vvvvvvvv
22
28
12
9
10
14
30
6
21
13
7
15
18
1. Remove and identify all loose parts from carton .
2. Position hopper on side. Install frame using (4) #14 x 1½” Flat Head Phillips
screws. TIGHTEN THESE NOW
12-2011 Pt# 52158 PAGE 1
2150T C
ommerCial
T
ow
B
roadCasT
s
preader
ASSEMBLY and OPERATING INSTRUCTIONS
EV-N-SPRED
EarthWay
R
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, EMAIL: [email protected]
HELPFUL HINTS:
READ THE DIRECTIONS BEFORE ASSEMBLY
; If your spreader does not spread evenly, be sure the word “FRONT” on the gear box points toward the tow bar of the
spreader. The impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise.
Clean the impeller plate after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pulled at three miles per hour, which is a brisk walking speed. Slower or faster speeds will
change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader
thoroughly after each use. Coat all metal surfaces (inside & outside of the chassis) with light oil or silicon spray to help
prevent corrosion. Wash between the shut-off plate and bottom of the hopper.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
OVER
3 MPH
Do not tow
faster than
3 MPH
ROCK SALT and POWDERED
MATERIALS should not be used in this
spreader as it will damage the gearbox and
can void the warranty.
Use only granular materials.