Earthway C25HDS Stainless Steel Professional Tow Broadcast Spreader - Manual (Page 2)

PAGE 2
3. Lift the d
rAw
b
Ar
into position and replace the ¼-20 x 2 ¼” bolts washer and nut as shown below. Now tighten those bolts
and the other frame bolts.
4. Install d
rive
w
heel
to the A
xle
using pin hole nearest to lower handles as shown. Insert 2” cotter pin through w
heel
and
through A
xle
. Bend with pliers to prevent pin from falling out.
5. Install C
oASt
w
heel
to A
xle
, using outside pin hole, insert the 1” cotter pin through A
xle
(not thru the wheel). Bend with
pliers to prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO WHEELS.
6. Remove the (2) ¼-20 x 1¾” bolts, washers, nuts, and p
ivot And
b
rACket
from the l
ower
h
AndleS
as shown below.
7. Install C
ontrol
S
upport
A
SSembly
by sliding between l
ower
h
AndleS
and inserting (2) 1¾” bolts thru the p
ivot
b
rACket
and the l
ower
h
AndleS
and secure
with (2) lock nuts and cupped washers
as shown below.
TIGHTEN ALL FASTENERS
NOW.
2” Cotter Pin
1” Cotter Pin
Remove Pivot Bracket
and ¼-20 x 1¾" Bolts,
cupped washers & lock nuts.
Slide the Control Assembly
into Lower Handles.
Next Replace Pivot Bracket
and ¼-20 x 1¾" Bolts, cupped
washers & lock nuts.
Rotate Draw
Bar up
Remove
bolts