Earthway 2150T Commercial Tow Broadcast Spreader - Manual (Page 5)

PAGE 5
The settings furnished on the Rate Setting Matrix are intended as a guide only. Variations in physical characteristics of
material applied, walking/towing speed, and roughness of ground surface may require slightly different spreader settings.
Due to the above conditions, the manufacturer makes no warranty as to the uniformity of coverage actually obtained from the
settings listed.
HOW TO ORDER SPARE PARTS
All spare parts listed herein may be ordered direct from the
manufacturer. Be sure to give the following information when
ordering.
; Model Number
; Part Number
; Part Description
You can contact us by calling (574) 848-7491 or 800-294-0671
to place an order with a credit card.
Questions? [email protected]
OPERATING INSTRUCTIONS
Before filling hopper, become familiar with the operation of this
spreader.
1. Obtain proper setting for material to be used from the RATE
SETTING CHART included with this spreader.
2. Move stop bolt on rate gauge assembly to the proper setting.
3. While pushing spreader forward, pull control lever back to
stop bolt.
4. To stop, push lever forward to close flow holes before you stop
moving.
5. When finished, empty any remaining material from hopper.
6. Thoroughly wash spreader and allow to dry before storing.
Light oiling can prevent corrosion.
Full Rate Path Half Rate Path
Start
Finish
Start
Finish
5-YEAR LIMITED WARRANTY
Earthway Products, Inc. warrants this product free of defects in original workmanship and materials for a period of 5-Years to the end user
with the original purchase receipt. If a manufacturing non-conformance is found, Earthway Products, Inc. at its discretion will repair or
replace the part(s) or product at no charge provided the failure is not the result of incorrect installation, mishandling, misuse, tampering,
or normal wear and tear as determined by Earthway. Earthway at its discretion may require that the part(s) or product be returned along
with the original purchase receipt at owners’ expense for examination and compliance with the terms of this warranty. Do not return any
product without first receiving authorization from Earthway Products, Inc. To seek remedy under this warranty, contact Earthway Products,
Inc. at 574-848-7491, [email protected] or write to Earthway Products, Inc. P.O. Box 547 Bristol, Indiana 46507 and describe
the nature of the manufacturing defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor charges
associated with repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of most fertilizers and ice
melt products, Earthway Products, Inc. makes no warranty against and specifically excludes part(s) or product degradation or failure due to
corrosion or its effects. Clean and dry your spreader thoroughly after each use, as a preventative measure, coat all metal parts (inside and
outside of the steel tubing) with a light oil or silicon spray.