Earthway 2150 Commercial Broadcast Spreader - Manual (Page 5)

PAGE 5
The settings furnished on the Rate Setting Matrix are intended as a guide only. Variations in physical characteristics of
material applied, walking speed, and roughness of ground surface may require slightly different spreader settings. Due to the
above conditions, the manufacturer makes no warranty as to the uniformity of coverage actually obtained from the settings
listed.
HOW TO ORDER SPARE PARTS
All spare parts listed herein may be ordered direct from the manufacturer. Be sure to give the following information when ordering.
; Model Number
; Part Number
; Part Description
You can contact us by calling (574) 848-7491 or 800-294-0671 to place an order with a credit card. Questions? [email protected]
FULL Rate
(one pass)
HALF Rate
(two passes)
SPREAD PATH
5-YEAR LIMITED WARRANTY
Earthway Products, Inc. warrants this product free of defects in original workmanship and materials for a period of 5-years
to the end user with the original purchase receipt. If a manufacturing non-conformance is found, Earthway Products, Inc.
at its discretion will repair or replace the part(s) or product at no charge provided the failure is not the result of incorrect
installation, mishandling, misuse, tampering, or normal wear and tear as determined by Earthway. Earthway at its
discretion may require that the part(s) or product be returned along with the original purchase receipt at owners’ expense for
examination and compliance with the terms of this warranty. Do not return any product without first receiving authorization
from Earthway Products, Inc. To seek remedy under this warranty, contact Earthway Products, Inc. at 574-848-7491,
[email protected] or write to Earthway Products, Inc. P.O. Box 547 Bristol, Indiana 46507 and describe the nature
of the manufacturing defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor
charges associated with repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of
most fertilizers and ice melt products, Earthway Products, Inc. makes no warranty against and specifically excludes part(s) or
product degradation or failure due to corrosion or its effects, or the use of powdered materials. Clean and dry your spreader
thoroughly after each use, as a preventative measure, coat all metal parts with a light oil or silicon spray.
OPERATING INSTRUCTIONS
Before filling hopper, become familiar with the operation of this spreader.
5
Obtain proper setting for material to be used from the enclosed SETTING MATRIX included with this spreader, or from
our web site under the MANUALS SECTION.
5
Move stop bolt on rate gauge assembly to the proper setting.
5
While pushing spreader forward, pull control lever back to stop bolt.
5
To stop, push lever forward to close flow holes before you stop moving.
5
When finished, empty any remaining material from hopper.
5
Thoroughly wash spreader and allow to dry before storing. A coating of light oil will help prevent corrosion.
5
If you use Rock Salt, remove agitator when in use to prevent damage to the gearbox.