Earthway 2100P Estate Broadcast Spreader - Manual (Page 3)

SLIDE
Gearbox
&
Axle
Drawbar
Frame Brace
Bushing
7. Slide axle bushing over axle and into axle bearing to both sides as shown.
8. Install drive wheel to axle using pin hole nearest to lower handles as shown. Insert 1¾”
Cotter pin through wheel and through axle. Bend with pliers to prevent pin from falling
out.
9. Install coast wheel to axle using outside pin hole. As shown, add the flat washer, and
insert ¾” Cotter pin through axle (
not thru thE whEEl
). Bend with pliers to prevent pin
from falling out.
1¾” Cotter Pin
¾” Cotter Pin
Flat Washer
10. Install Control Assembly by inserting bent wire end into the small
hole in the shut-off plate from the bottom of the spreader as shown
above. TIP: The wire will fit into the hole to the first bend, then you need
to lay the Control Wire into the Lower Housing Clip. Close the Lower
Housing Clip with a snap and secure with #10 x ⅝” Screw and snug to a
loose fit - d
o not
t
ightEn
.
TURN SPREADER UPRIGHT ON TO WHEELS.
#10 x 5/8”
Screw
Lower Housing Clip
Larger Hole
PAGE 3
Rate Handle
Control
Wire
Control
Assembly
Shut-Off
Plate
Small
hole for wire
#30
Lower Housing Clip
Control Wire
Larger Hole