FIREPOWER Firefinder XLS - Manual (Page 4)

s Industry, Inc.
Building Technologies Division
Model HLIM does not occupy a device address on the Model
DLC circuit, and does not require programming. Up to 15
Model HLIM modules may be installed on each Model
DLC loop.
HCP Control Point Module
HCP
Model HCP provides an intelligent control point for the
FireFinder XLS Control Panel. Model HCP can be
programmed as an independent, remotely located tele-
phone zone, speaker zone or notification appliance circuit.
Model HCP is designed to be used with the Siemens Fire
Safety Notification-Appliance Circuits product line.
Model HCP communicates through the Model DLC analog
loop, and can be wired either Class A (Style Z) or Class B
(Style Y). The 24 VDC power input comes from either the
control panel or from any UL listed power-limited,
auxiliary-power supply.
CRC-6 Controllable Relay Card
CRC-6 Controllable Relay Card
The Controllable Relay Card (Model CRC-6) is used with
the FireFinder XLS FACP. Model CRC-6 is designed to
provide auxiliary control of building functions, such as:
door-holder release, elevator capture, smoke control, lock
release, etc. Model CRC-6 plugs into one (1) slot in the
Model CC-5 or Model CC-2 card cage. Model CRC-6
provides six (6), fully programmable relays. Each relay
contains one (1) set of SPDT contacts rated at 4 Amps 30 VDC
/ 120 VAC resistive and 3.5 amps 120 VAC inductive (0.6
P.F.)
SIM-16 Supervised Input Module
SIM-16 Supervised Input Module
The Supervised input Module (Model SIM-16) is a
remotely located, general-purpose input module. Model
SIM-16 provides 16 input circuits for remote system
monitoring. Each input can be individually programmed
as supervised (dry-contact only) or unsupervised (general-
purpose input.) Model SIM-16 has two (2) Form C relays.
The relays and inputs are programmed using the Zeus
system software-programming tool.
CDC-4 Conventional Detector Card
CDC-4
The Conventional Detector Card (Model CDC-4) is used to
monitor Siemens Fire Safety conventional detectors on the
FireFinder XLS system. Model CDC-4 can be used in
applications where conventional detectors are more suited
than addressable detectors, such as hallways or large
meeting rooms. Also, Model CDC-4 can be used to
upgrade Siemens conventional fire-alarm panels to the
FireFinder XLS system without requiring detector
replacement.
CC-2 Card Cage-2 Slots CC-5 Card Cage-5 Slots
CC-5 / CC-2 Card Cages
The Models CC-5 / CC-2 card cages provide the physical
mounting location and all wiring connection points for all
fire-and-voice system options cards for the FireFinder XLS
system. Model CC-5 has five (5) slots, while Model CC-2
has two (2) slots.