FIREPOWER 5700 User Manual
Model 5700 basic operating instructions

Cut Along the
Dotted
Line
Model 5700 Basic Operating Instructions
These Instructions must be framed and displayed next to the 5700 panel in
accordance with NFPA 72 fire code for Local Protected Fire Alarm Systems.
Test the system in accordance to NFPA 72. Refer to Installation Manual P/N
151295.
Operation
Task to Perform
Silence Alarms and Troubles
Press
then enter a code if prompted. Silence LED will light.
Reset Alarms
Press
then enter a code if prompted.
Acknowledge Alarms and
Troubles
Press
then enter a code if prompted. When the Alarm or Trouble is
acknowledged an
A will appear in the annunciator display as shown Below.
View Alarms and Troubles
Press the
or
button to view Alarms and Troubles.
Conduct a Fire Drill
1. Press
to access Main Menu, then enter a code if prompted.
2. Then press
to select System Tests.
3. Enter code if prompted, then press
to select Fire Drill.
4. Press
to start the fire drill.
5. Press
to end the fire drill.
View a Points Status
1. Press
to access Main Menu, then enter a code if prompted.
2. Then press
to select Point Functions.
3. Enter code if prompted, then press
to select Point Status.
4. Select the module the device is located on by using the
or
. Then press
.
5. Enter the point number.
Check Detector Sensitivity
1. Follow steps 1 through 5 for viewing a point status.
2. Press
to view detector sensitivity.
Set Time and Date
1. Press
to access Main Menu, then enter a code if prompted.
2. Then press
to select Set Time & Date. Enter a code if prompted
3. Make changes in the fields on the screen as necessary.
4. Press
if you wish to keep the changes.
5. Press
to set the entered time and date.
Enable / Disable a Point
1. Press
to access Main Menu, then enter a code if prompted.
2. Then press
to select Point Functions.
3. Enter code if prompted, then press
to select Disable / Enable Pt.
4. Select the module the point is located on by using the
or
. Then press
.
5. Enter the point number.
View Event History
1. Press
to access Main Menu, then enter a code if prompted.
2. Press
to select Event History.
3. Press the
or
to view events in the history buffer.
For Service call:
P/N 151297
Rev. B
Acknowledge
Mark
1
1
2
2
4
2
1
3