FEC AFC1100 - Manual (Page 8)

)(& ,QF
7.2.3 Fastening results display mode.
In fastening results display mode (when [D-NO] shows _0 ~
≡≡≡≡
4), data can be obtained by
pressing the [ ↓↓↓↓ ] and [ ↑↑↑↑ ] keys to scroll [D-NO] until the desired DATA item is displayed. The
following information will be displayed in the [DATA] and [ANGL/SPNO] display sections for
the displayed [D-NO]:
ANGLE @ PEAK TORQUE. FINAL TORQUE. ≡≡≡≡
4
1ST PEAK ANGLE. 1ST PEAK TORQUE. ≡≡≡≡
3
1ST FINAL ANGLE. 1ST FINAL TORQUE ≡≡≡≡
2
2ND INCREMENT ANGLE. 2ND INCREMENT TORQUE. ≡≡≡≡
1
1ST INCREMENT ANGLE. 1ST INCREMENT TORQUE.
≡≡≡≡
0
5: ACCEPT.
4: REJECT.
3: STOP SIGNAL.
2: BYPASS SIGNAL.
1: ABNORMAL SIGNAL.
0: RESET / NO DATA / AFTER REVERSE.
SPINDLE NO CAUSE OF FASTENING STOP: =5
SPINDLE NO REVERSE FLAG (ON: BACKED OUT, OFF: NOT BACKED
OUT) =4
SPINDLE NO SELF CHECK (ON: enabled, OFF: disabled) =3
SPINDLE NO NOT USED =2
SPINDLE NO FASTENING STEPS =1
SPINDLE NO FASTENING MODE.
====
0
SPINDLE NO FASTENING MODE. _7
SPINDLE NO CYCLE TIME _6
SPINDLE NO FINAL STEP TIME. _5
SPINDLE NO. 1ST STEP TIME. _4
SPINDLE NO 2ND TORQUE RATE. _3
SPINDLE NO. 1ST TORQUE RATE _2
SPINDLE NO. FINAL ANGLE _1
FINAL ANGLE. PEAK TORQUE. _0
ANGL/SPNO DATA D-No
D-NO
DATA
PEAK TORQUE
FINAL ANGLE
OR
ANG/SPNO
_
_0
_1
_2
_3
1ST TORQUE RATE
2ND TORQUE RATE
(DISPLAY [D-No] DATA DISPLAYED
FIG. 7-2-3 Fastening results display selection
Chapter 7: System Operations (Rev. 8/98)
Page 7-8