SPP Pumps Auto Prime Q Series - Workshop Manual - Manual (Page 4)

Manual No/Rev
W72-021E / 8
Workshop Manual for
AUTOPRIME Q Range Pump Units
Our policy is one of continuous improvement and we reserve the right to alter specifications at any time
Page 4 of 36
1. INTRODUCTION
The purpose of this handbook is to give
instructions
for the disassembly and
reassembly of the SPP AUTOPRIME Q
Range of diesel engine driven pumps.
Instructions and statements contained within
this handbook are given with our best
intentions and are correct at the time of
compilation. They are subject to alteration at
any time.
These pumps are most commonly supplied
mounted on 2 wheel road trailers but can
also be supplied on site trailers, skid
mounted, or as a pod unit for customer’s to
mount on suitable foundations.
A range of optional equipment is available.
Please refer to section 9 for details.
This manual covers the following pump configurations:
Standard Pump configuration from June 2007
Pump
Type
Engine Fuel
Tank Priming
System
Control
Panel
QI 100 Isuzu 3CE1 220L
Single
Probe
Electric
Prime Fixed or
Variable
Speed
Control
QI 150 Isuzu 3CE1 220L
QI 150M Isuzu 4LE2 220L
QC150M Cat 3024 2.2 220L
QI 200
Isuzu 4LE2 220L
QHH80 Isuzu 4LE2 220L
All pumps can be supplied with European standard trailers having
fixed (EF) or variable (EV) height, ring or ball type tow hitches.
Pumps can also be supplied mounted on skids or as a pod for
customers to mount on vehicles or other equipment as required.
Note: For special, non standard specifications for pumps not listed above, many parts will be common
BUT refer to SPP Pumps Limited for confirmation of part numbers before ordering spare parts.
Pump Main Components
VACUUM
PUMP
COALESCER
(far side) PRIMING TANK
AIR FILTER CONTROL
PANEL
RADIATOR
FILLER CAP
EXHAUST
SILENCER
FRONT
PANEL
VACUUM PUMP
DRIVE BELT
AND CLUTCH
PRIMING
TANK
DRIVE END
SHAFT BEARING FUEL
FILLER PUMP END
SHAFT BEARINGS SUCTION
FLANGE
DELIVERY
FLANGE
NON
RETURN
VALVE
UNIT
LIFTER
VOLUTE
SOLENOID
VALVE
MECHANICAL
SEAL OIL
RESERVOIR