Alamo FC-0002 - Manual (Page 14)

SAFETY
SAMURAI 12/08 Safety Section 1-10
©2008 Alamo Group Inc.
SAFETY
There are obvious and hidden potential hazards in the operation of this
Mower. REMEMBER! This machine is often operated in heavy brush
and in heavy weeds. The Blades of this Mower can throw objects if
shields are not properly installed and maintained. Serious injury or even death may occur
unless care is taken to insure the safety of the operator, bystanders, or passersby in the
area. Do not operate this machine with anyone in the immediate area. Stop mowing if
anyone is within 100 yards of mower.
(SGM-2)
The rotating parts of this machine have been designed and tested for rugged use.
However, the blades could fail upon impact with heavy, solid objects such as metal guard
rails and concrete structures. Such impact could cause the broken objects to be thrown
outward at very high velocities. To reduce the possibility of property damage, serious
injury, or even death, never allow the cutting blades to contact such obstacles.
(SGM-4)
Extreme care should be taken when operating near loose objects such
as gravel, rocks, wire, and other debris. Inspect the area before
mowing. Foreign objects should be removed from the site to prevent
machine damage and/or bodily injury or even death. Any objects that cannot be removed
must be clearly marked and carefully avoided by the operator. Stop mowing immediately if
blades strike a foreign object. Repair all damage and make certain rotor or blade carrier is
balanced before resuming mowing.
(SGM-5)
Many varied objects, such as wire, cable, rope, or chains, can become entangled in the
operating parts of the mower head. These items could then swing outside the housing at
greater velocities than the blades. Such a situation is extremely hazardous and could result
in serious injury or even death. Inspect the cutting area for such objects before mowing. Remove any like
object from the site. Never allow the cutting blades to contact such items.
(SGM-6)
Mow at the speed that you can safely operate and control the tractor and mower. The
correct mowing speed depends on terrain condition and grass type, density, and height of
cut. Normal ground speed range is from 2 to 5 mph(3-8 kph). Use slow mowing speeds
when operating on or near steep slopes, ditches, drop-offs, overhead obstructions, power lines, or when
debris and foreign objects are to be avoided.
(SGM-7)
Avoid mowing in reverse direction when possible. Check to make sure there are no
persons behind the mower and use extreme care when mowing in reverse. Mow only at a
slow ground speed where you can safely operate and control the tractor and mower.
Never mow an area that you have not inspected and removed debris or foreign material.
(SGM-8)
Do not mow with two machines in the same area except with Cab tractors with the windows
closed.
(SGM-11)