Fulton Ancillary Equipment SteamPac Unfired Steam Generators - Manual (Page 10)

Fulton Thermal Corp.*SteamPac Unfired Steam Generators Manual* Version 2010-0201
Page 10
Warning
Prior to the commencement of any work requiring the removal of cover plates and the opening of
the control panel box, the electrical supply to the boiler must be disconnected.
When stopping the SteamPac for any extensive repairs, shut off main disconnect switches on
both the boiler side as well as the feed water side.
Note
To ensure the continued safety and efficiency of the SteamPac, the schedule of maintenance
outlined in this manual should be adhered to.
Note
Fulton recommends that the feedwater treatment should be added between the pump and the
SteamPac.
Warning
Make sure main power switch is off before starting work.
Caution
Do not clean the gauge or glass while pressurized or in operation.
Note
All of the above maintenance procedures should be completed by trained personnel. Appropriate
training and instructions are available from the Fulton Service Department at (315) 298-7148 or
your local Fulton Thermal Representative.
Note
Room temperature not to exceed 100
o
F.