beautypg.com

Electrical connection, Prior to installation, Circulating-air mode – Bosch DWA091450 - inox Hotte décorative murale 90 cm User Manual

Page 11: Preparing the wall

background image

11

Circulating-air mode

❑ With activated

carbon filter if
exhaust-air mode
is not possible.

Electrical connection

Risk of electric shock!

The appliance features an EU safety plug. To
ensure protective earthing in a Danish
socket, the appliance must be connected to a
suitable plug adapter. This adapter
(permitted up to max. 13 amps) is available
from customer service (spare part no.
616581).

The mains power supply must correspond to
the rating indicated on the plate situated
inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in an
accessible area. If it not fitted with a plug
(direct mains connection) or if the plug is not
located in an accessible area apply a bi-
polar switch in accordance with standards
which assures the complete disconnection of
the mains under conditions relating to over-
current category III, in accordance with
installation instructions.

Warning! Before re-connecting the hood
circuit to the mains supply and checking the
efficient function, always check that the
mains cable is correctly assembled.

Warning! Power cable replacement must be
undertaken by the authorized service
assistance centre or similar qualified person.

Connect the hood to a norm complying plug
only. The plug should be located in an
accessible zone.
❑ The plug must be equipped with a

protection circuit.

❑ If after installation the plug can not be

reached, a disconnecting device must be
envisaged.

Circulating-air
mode

60 cm

90 cm

Exhaust-air
mode

10,3

13,2

11,5

14,4

30

396

419

375

MAX. 1171

MIND. 887

598 - (898)

490

(522)

MIND. 95

MAX. 375

490

Prior to installation

The complete installation set can be

obtained from specialist outlets.

The corresponding accessory numbers can
be found at the end of these operating
instructions.

Preparing the wall

❑ The wall must be flat and perpendicular.
❑ Ensure that the wall is capable of

providing a firm hold for mounting screws
and plugs.

Weight in kg:

We reserve the right to construction changes
within the context of technical development.

This manual is related to the following products: