PROLiNK IPS5000 - Manual (Page 5)

- 3 -
9. Be extra cautious when working with metal tools on, or around batteries. The potential exists to
drop a tool and short-circuit the batteries or other electrical parts resulting in sparks that could
cause an explosion.
10. No AC or DC disconnects are provided as an integral part of this unit. Both AC and DC
disconnects must be provided as part of the system installation. See INSTALLATION section of
this manual.
11. No over current protection for the battery supply is provided as an integral part of this unit. Over
current protection of the battery cables must be provided as part of the system installation. See
INSTALLATION section of this manual.
12. GROUNDING INSTRUCTIONS -This battery charger should be connected to a grounded
permanent wiring system. For most installations, the Ground Lug should be bonded to the
grounding system at one (and only one point) in the system. All installations should comply with
all national and local codes and ordinances.
Personal Precautions
1. Someone should be within range of your voice to come to your aid when you work near batteries.
2. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
3. Wear complete eye protection and clothing protection. Avoid touching eyes while working near
batteries. Wash your hands when done.
4. If battery acid contacts skin or clothing, wash immediately soap and water. If acid enters eyes,
immediately flood eyes with running cool water for at least 15 minutes and get medical attention
immediately.
5. Baking soda neutralizes lead acid battery electrolyte. Keep a supply on hand in the area of the
batteries.
6. NEVER smoke or allow a spark or flame in vicinity of a battery or generator.
7. Be extra cautious when working with metal tools on, and around batteries. Potential exists to
short-circuit the batteries or other electrical parts which may result in a spark which could cause
an explosion.
8. Remove personal metal items such as rings, bracelets, necklaces, and watches when working
with a battery. A battery can produce a short-circuit current high enough to weld a ring, or the like,
to metal causing severe burns.
9. If a remote or automatic generator start system is used, disable the automatic starting circuit
and/or disconnect the generator from its starting battery while servicing to prevent accidental
starting during servicing.