PROLiNK PWH2004 User Manual - Manual (Page 19)

PROLiNK ® PWH2004 User Manual www.prolink2u.com
Revision 1.0 (Aug’09) 17
DHCP Type
Disable: Select to disable this Wireless Router to distribute IP addresses to
connected clients. Server: Select to enable this Wireless Router to distribute IP
Addresses (DHCP Server) to connected clients. And the following field will be
activated for you to enter the starting IP Address.
Start IP Address
The starting addresses of this local IP network address pool. The pool is a piece
of continuous IP address segment. Keep the default value 192.168.1.100 should
work for most cases.
End IP address
The end IP address, the maximum is 254. If “Start IP Address” is set at
192.168.1.100 and the “End IP address” is 192.168.1.200, the device will
distribute IP addresses from 192.168.1.100 to 192.168.1.200 to all the
computers in the network that request IP addresses from DHCP server (Router).
Subnet Mask
The subnet mask of the distribute IP addresses clients, the subnet mask must be
set at the same segment as the Wireless Router.
DHCP Primary
DNS Server
You can specify your own preferred DNS server IP address(es).
DHCP Secondary
DNS Server Secondary DNS Server is optional. You can enter another DNS server’s IP
address as a backup.
Default Gateway Shows the default gateway IP address.
Lease Time
The lease time of the distribute IP Addresses. Default settings are 86400
seconds.
Statically Assigned
MAC: Enter the MAC address of a certain station, and then the DHCP Server will
to distribute a fixed IP address to the station automatically once be connected.
IP: Enter the fixed IP address that DHCP Server assigned to a certain connected
station. User can set up 3 set of fixed IP addresses that distribute form the
Wireless Router when the DHCP Type function be selected to Server.
UPNP
Universal Plug and Play (UPnP) is a set of computer protocols promulgated by
the UPnP Forum. The goals of UPnP are to allow devices to connect seamlessly
and to simplify the implementation of networks in the home (data sharing,
communications, and entertainment) and in corporate environments for
simplified installation of computer components. UPnP achieves this by defining
and publishing UPnP device control protocols built upon open, Internet-based
communication standards. The term UPnP is derived from plug-and-play, a
technology for dynamically attaching devices directly to a computer. Select
Disable or Enable from the pull-down menu.
PPPoE Relay Select Disable or Enable from the pull-down menu.
DNS Proxy Select Disable or Enable from the pull-down menu.
Apply
After completing the settings on this page, click Apply button to save the
settings.
Cancel Click Cancel to restore to default values.