PROLiNK PWH2004 User Manual - Manual (Page 16)

PROLiNK ® PWH2004 User Manual www.prolink2u.com
Revision 1.0 (Aug’09) 14
4.4.3. LAN
This step can set up local area network of the Wireless Router, such as IP address, subnet mask, DHCP type,
DHCP IP addresses range, and DHCP subnet mask and DHCP lease time.
IP Address Shows the IP address of the Wireless Router (Default IP address is 192.168.1.1).
Subnet Mask The subnet mask of the Wireless Router (Default subnet mask is 255.255.255.0).
DHCP Type
Disable: Select to disable this Wireless Router to distribute IP addresses to
connected clients.
Server: Select to enable this Wireless Router to distribute IP Addresses (DHCP
Server) to connected clients. And the following field will be activated for
you to enter the starting IP Address.
Start IP Address
The starting addresses of this local IP network address pool. The pool is a piece of
continuous IP address segment. Keep the default value 192.168.1.100 should work
for most cases.
End IP Address
The end IP address, the maximum is 254. If “Start IP Address” is set at
192.168.1.100 and the “End IP address” is 192.168.1.200, the device will distribute
IP addresses from 192.168.1.100 to 192.168.1.200 to all the computers in the
network that request IP addresses from DHCP server (Router).
Subnet Mask
The subnet mask of the distribute IP addresses clients, the subnet mask must be
set at the same segment as the Wireless Router.
Primary &
Secondary
DNS Server
The DNS should be set to the address provided by your ISP.
Default Gateway Enter the default gateway IP address provided by your ISP in this column.
Lease Time The lease time of the distribute IP Addresses. Default settings are 86400 seconds.