PowerMadd CargoCaddy Ski-Doo 13733 - Manual (Page 2)

P
OWER
M
ADD
®
1-800-435-6881
www.powermadd.com
PP5043 REV A
Step 5: Tape the paper template on top of the clutch guard, lining up the front
edge of the template with the edge of the last vent. Make sure the longest
edges of the template are parallel to the length of the clutch guard. Also
use these edges to center the template on the clutch guard.
Step 6: Place the CargoCaddy on the clutch guard with the clutch guard installed
on the snowmobile. Line up the four holes in the brackets with the four
marks on the template. Make sure the CargoCaddy isn’t touching the
engine or any other components. Also check to see if the hood closes
properly.
NOTE: On some snowmobiles the hood foam may come in contact with the CargoCaddy and cause the hood not to
close completely. The hood foam should take a set after a short period of time and let the hood close properly, or
you may choose to remove some of the hood foam.
Step 7: Use a center punch to mark the four locations to drill through the clutch guard. Be sure to make your marks
as close to the center of the circle as possible.
Step 8: Remove the paper template and drill through the clutch guard with a 7/32” drill bit at the four locations.
Step 9: Rivet the CargoCaddy to the clutch guard at the four locations from underneath the clutch guard so the heads
of the rivets are towards the primary clutch.
Step 10: Position each of the 5 top foam pieces to the underside of the cover,
between each of the 4 reference lines. Remove adhesive backer from
each foam piece and affix to lid. NOTE: Adhesive cannot be
repositioned.
Step 11: Place bottom foam liner into bottom of CargoCaddy and install dividers
into desired positions.
LIMITED WARRANTY
P
OWER
M
ADD
warrants this product to be free from defects in material and workmanship under use for the purpose it was
intended. P
OWER
M
ADD
shall not be liable for damage or injury caused by defective materials or workmanship.
P
OWER
M
ADD
may elect to repair or replace this product, but is the sole judge of any defects in their product. This
warranty does not cover any labor costs to remove or reinstall this product and is effect for one year from the original
purchase date.