PowerMadd CargoCaddy Ski-Doo 13733 - Manual

P
OWER
M
ADD
®
1-800-435-6881
www.powermadd.com
PP5043 REV A
P
OWER
M
ADD
®
Ski-Doo CargoCaddy
TM
Installation Instructions for Part No. 13733
NOTE: This instruction sheet #PP5043 is for Ski-Doo snowmobiles that utilize the vented clutch guard in the MXZ
chassis. Older Ski-Doo snowmobiles without the vented clutch guard should use the universal instruction sheet #PP5011.
HARDWARE INLCUDED: TOOLS REQUIERED: OTHER AVAILABLE MODELS:
Qty Description Power Drill Part No. Description
1 CargoCaddy 7/32” & Drill Bit 13730 Universal
3 Dividers Pop Rivet Gun 13731 Polaris Edge Chassis
5 Foam Top Pads Center Punch 13732 Arctic ZR Chassis, 2000 & Newer
1 Foam Bottom Scissors (won’t fit ZR 800 or ZR 900)
2 Mounting Brackets Tape
8 3/16” Pop Rivets
1 Spare Belt Bracket (for universal mount only)
WARNING: Read all instruction prior to installation. Never work on a snowmobile while snowmobile is running.
Before any drilling is done to your snowmobile, take adequate precautions to be sure no debris will end up in your
clutches or any other areas that may cause damage or injury. If possible, remove the clutch guard from the
snowmobile before drilling any holes or doing any riveting, this will make installation cleaner and easier.
Step 1: Drill through the bottom of the CargoCaddy from inside at bosses #1,
#3, #4 and #6 with a 7/32” drill bit.
Step 2: Rivet the brackets to the bottom of the CargoCaddy as shown in the picture.
Step 3: Remove any previously installed spare spark plug or drive belt holders from the top of the clutch guard that
will interfere with the CargoCaddy.
Step 4: Carefully cut out the paper mounting template along the dotted line. NOTE: It will be easier to line up
with the clutch guard if the template is cut out accurately.