PowerMadd Star Series PM14269 Tri-Mount - Manual

Figure 1
Tri-Mount
Installation Instructions for Part No. PM14269
HARDWARE INCLUDED: TOOLS REQUIRED:
Qty Description -4mm hex wrench
2 Rod Mount -10mm wrench
2 Handle Bar Mount -17mm wrench
2 Duckbill Spacer
4 10mm Nut
2 6mm Lock Nut
2 6mm Bolt
4 Washers
READ ALL INSTRUCTIONS CAREFULLY BEFORE
INSTALLATION!
NOTE: PowerMadd’s Tri-mount is designed to mount to the upward
sweep section of your handle bars (see the Figure 1).
STEP 1:
Thread the rod mount into the handle bar mount. Do not
tighten yet, you will need to adjust this later.
STEP 2:
Install the handle bar mount onto the upward sweep of
your bars (see Figure 1).
STEP 3: Remove the 6mm lock nut and 6mm bolt from the
Duckbill spacer. The Duckbill spacer goes between the two mounting
tabs of your hand guard. Mount the guard as shown in Figure 2.
Slide the 6mm bolt through both the hand guard tabs and Duckbill
spacer. Do not install lock nut yet. There are more adjustments to be
made.
STEP 4:
Position the handle bar mount so that the spine of the
hand guard is close to parallel with your hand grips and with enough
space to operate your levers. This can be accomplished by moving the
handle bar mount up and down on your handle bars and twisting on
your handle bars and by rotating the rod mount up and down. Once
you get the guards where you want them, tighten the handle bar
mount with a 4mm hex wrench, and then tighten the jam nut on the
rod mount against the bar mount using a 17mm wrench so the rod is
locked into place.
STEP 5:
Position the hand guard so that the end of the hand guard
is even with the end of your handle bars. Also, adjust the tilt of the
hand guard to your personal taste. This can be accomplished by
spinning the two jam nuts and Duckbill spacer in or out as needed.
You will need to remove your hand guard for this adjustment. Once
you have your adjustments tighten the two 10mm jam nuts with
17mm wrenches. Install the hand guard as you did in step 3 but this
time install the 6mm lock nut and tighten with 10mm wrench. Repeat
the same steps for the other side and you’re done.
Note: Recheck all fasteners to tightness after first couple of riders.
LIMITED WARRANTY
POWERMADD warrants this product to be free from defects in material and workmanship under use for the purpose it was intended. POWERMADD shall not be
liable for damage or injury caused by defective materials or workmanship. POWERMADD may elect to repair or replace this product, but is the sole judge of any
defects in their product. This warranty does not cover any labor costs to remove or reinstall this product and is effect for one year from the original purchase date.
POWERMADD ® IN14269
651-462-8465 www.powermadd.com
Figure 2