PowerMadd Star Series 34253 Hand Wrap Kit - Manual

PowerMadd
M 34253 Rev C
651-462-8465 www.powermadd.com
P
OWER
M
ADD
® Hand Wrap Kit
Installation Instructions for Part No. 34253
NOTE: This kit is an accessory to the Star Series Handguard and Handguard Mounting Kit.
HARDWARE INCLUDED:
TOOLS REQUIRED:
Qty Description Power Drill
2 Brackets 3/16” Drill Bit
2 Flat Head Screws 1/4” Drill Bit
2 Button Head Screws 5mm Hex Wrench
2 Clamp Inserts 4mm Hex Wrench
2 Cone Inserts Hack Saw
2 Rubber Hose Utility Knife
2 Flange Nut
NOTE: Both Hand Wrap brackets have a bend next to where they mount to the handlebar to give relief for the hands. One
bracket is specifically for the throttle side and the other is for the clutch side. These instructions will explain how to install one
side. Then repeat the instructions for the other side. You must have 7/8” bars that are hollow for this system to work.
STEP 1: Take one of the Hand Wrap brackets and clamp the end
without the threaded hole into a vise. It will require two hands
to drill the hole in the handguard for mounting the bracket.
STEP 2: The end of the bracket with the threaded hole fits into the
backside of the handguard. With a 3/16” drill bit and using the
threaded hole as a guide, drill through the handguard as you
hold it up to the bracket.
STEP 3: Remove the handguard from the bracket and use a 1/4” drill bit
to increase the size of the hole drilled in the handguard from
STEP 2. Repeat STEP 1-3 for other handguard.
NOTE: If your handlebar setup already has holes in the end of each grip,
skip to STEP 5, otherwise continue with STEP 4.
STEP 4: Clutch Side: Cut or drill a ½” hole in the end of the grip or
completely cut the end of the grip off. The best way is to drill
a hole in the grip.
Throttle Side: Remove the throttle tube from the handlebars.
Cut or drill a 9/16” hole in the end of the grip and throttle tube
or use a knife to cut off the end of the grip and a hack saw to
cut off the end of the tube. Then reinstall the throttle tube onto
the handle bars.