beautypg.com

Ower – PowerMadd CargoCaddy Arctic Cat 13732 User Manual

Page 2

background image

P

OWER

M

ADD

®

1-800-435-6881

www.powermadd.com

PP5042 REV A

Step 4:

Carefully cut out the paper mounting template along the dotted line. NOTE: It will be easier to line up
with the clutch guard if the template is cut out accurately.

Step 5:

Tape the paper template on top of the clutch guard, lining up the two

solid lines with the outside edges of the hinge and the left edge with the
edge of the guard. The four rivets for the hinge should be centered in the
slotted cutouts in the paper template.

Step 6:

Place the CargoCaddy on the clutch guard with clutch guard installed in
the snowmobile. Line up the six holes in the brackets and the six marks
on the template. Make sure the CargoCaddy isn’t touching the engine or
any other components. Also check to see if the hood closes properly.

Step 7:

Use a center punch to mark the six locations to drill through the clutch guard. Be sure to make your marks as
close to the center of the circle as possible.

Step 8:

Remove the paper template and drill through the clutch guard with a
7/32” drill bit at the six locations. You may want to start with a smaller
bit to keep the holes centered on the marks.

Step 9:

The six holes in the brackets the CargoCaddy should line up with the
holes you just drilled in the clutch guard. Insert the rivets by hand, but if
a couple holes don’t match up, first complete riveting the ones you were
able to insert. Then use a 3/16” drill bit to re-drill the holes that didn’t
match up. You will now be able to insert the last rivets and complete the
riveting.

Step 10:

Position each of the 5 top foam pieces to the underside of the cover,
between each of the 4 reference lines. Remove adhesive backer from
each foam piece and affix to lid. NOTE: Adhesive cannot be
repositioned.

Step 11:

Place bottom foam liner into bottom of CargoCaddy and install dividers
into desired positions.

LIMITED WARRANTY

P

OWER

M

ADD

warrants this product to be free from defects in material and workmanship under use for the purpose it was

intended. P

OWER

M

ADD

shall not be liable for damage or injury caused by defective materials or workmanship.

P

OWER

M

ADD

may elect to repair or replace this product, but is the sole judge of any defects in their product. This

warranty does not cover any labor costs to remove or reinstall this product and is effect for one year from the original
purchase date.