PowerMadd Seat Wedge – Arctic Cat F Series 51055 - Manual (Page 2)

6. Drill a 3/16” hole approximately 7” from the back
of the tunnel see Figure 4. Keep downward
pressure on the Seat Wedge as you are drilling to
ensure correct positioning. Do this for both sides of
the tunnel
7. Install 3/16” rivets from the bottom side of the
tunnel (track side) through the tunnel and Seat
Wedge. Place a 3/16” rivet washer on the rivet by
placing your hand through the hole cut out on top
of the Seat Wedge. Repeat for the other side of
tunnel. Note: Keep downward pressure on the
Seat Wedge as you are installing the rivets.
8. Screw the 2” stud into the insert on top of the Seat
Wedge. See Figure 5.
9. Place the factory seat on the top of the Seat Wedge.
Line up and push the two front seat prongs into
their original position then lower the seat so the
stud passes through the mounting hole in the seat.
Through the rear storage compartment place the
fender washer onto the stud and secure with ¼-20
flange nut. Figure 1
10. Do a final check to make sure everything is
lined up and securely installed. After your final
check, your new Seat Wedge Riser installation is
complete and you are ready to ride comfortable.
Periodically check fasteners for tightness.
Limited Warranty: Your Seat Wedge comes with a with a non-transferable 1 year Warranty from the original purchase date
against manufacturer defects in workmanship and material under use it was intended for. This warranty relates to the
rotationally molded Seat Wedge only; no other wiring, hardware, or electrical components would apply. No other warranties
are expressed or implied and by consumer purchase, releases Powermadd and any other of their affiliates harmless from any
other possible claim except as in the stated warranty. Powermadd shall not be liable for damage or injury caused by defective
materials or workmanship. Consumer is responsible to insure installation is performed correctly in a safe and responsible
manner. Powermadd may elect to repair or replace this product, but is the sole judge of any defects in this product. This
warranty does not cover any labor costs to remove or reinstall this product.
Figure 4
Figure 5