PowerMadd Seat Wedge – Arctic Cat 51060 - Manual (Page 2)

POWERMADD PP5083 REV A
800.435.6881
www.powermadd.com
2
screws have been started; then tighten all six screws securely. Caution: Do not over-
tighten screws.
14. Using the original seat hold down washers and newly supplied screws, attach the seat to
the Seat Wedge through the rear storage compartment. Tighten until secure.
15. Reinstall the four rear suspension bolts.
16. Do a final check to make sure everything is lined up and securely installed. Your
finished installation should as it appears in Figure 3. After your final check, your new
Seat Wedge Riser installation is complete and you are ready to ride.
Limited Warranty
Your Seat Wedge comes with a non-transferable 1 year Warranty from the original purchase date against manufacturer defects in
workmanship and material under use it was intended for. This warranty relates to the rotationally molded Seat Wedge only; no other
wiring, hardware, or electrical components would apply. No other warranties are expressed or implied and by consumer purchase,
releases PowerMadd and any other of their affiliates harmless from any other possible claim except as in the stated warranty.
PowerMadd shall not be liable for damage or injury caused by defective materials or workmanship. Consumer is responsible to
insure installation is performed correctly in a safe and responsible manner. PowerMadd may elect to repair or replace this product,
but is the sole judge of any defects in this product. This warranty does not cover any labor costs to remove or reinstall this product.