PowerMadd Star Series 34253 Hand Wrap Kit - Manual (Page 2)

PowerMadd
M 34253 Rev C
651-462-8465 www.powermadd.com
STEP 5: Aluminum Handlebars: Assemble the Hand Wrap clamp onto
the bracket by inserting the flat head screw through the bracket
and threading into the cone (as shown in picture). Insert the clamp
assembly into the end of the handlebar and tighten the flat head
screw with a 5mm hex wrench so the bracket is slightly loose.
Steel Handlebars: Assemble the Hand Wrap clamp onto the
bracket by inserting the flat head screw through the bracket,
sliding on the rubber tube and threading the flange nut onto the
screw (as shown in the picture). Insert the clamp assembly into
the end of the handlebar and tighten the flat head screw with a
5mm hex wrench so the bracket is slightly loose.
Helpful Hint: Apply lubricant between the flat head bolt and the
bracket. This will enable you to get the hand wrap clamped
tighter to the handlebars.
STEP 6: Attach the handguards to the bracket with a button head screw and 4mm hex wrench. Then rotate the
handguards to the final desired position and tighten the clamp screw until the brackets don’t move.
STEP 7: Use the Handguard Mounting Kit (Part No.34252
for ATVs/Motorcycles) to finish mounting the
handguard to the handlebars. Choose the desired
mounting location and follow the installation
instructions from the handguard mounting kit to
complete the installation.
Helpful Hint: Attach the mounting bracket and
strap to the handlebar first. Then flex the
handguard to line up the holes in the mounting
bracket to the mounting holes in the handguard.
Helpful Hint: To remove the clamp from inside the handlebars, first loosen the flat head screw 3 - 4 turns, then tap
the head of the screw to push the cone further inside so the clamp will slide out.
LIMITED WARRANTY
POWERMADD warrants this product to be free from defects in material and workmanship under use for the purpose it was intended. POWERMADD shall not be liable for
damage or injury caused by defective materials or workmanship. POWERMADD may elect to repair or replace this product, but is the sole judge of any defects in their
product. This warranty does not cover any labor costs to remove or reinstall this product and is effect for one year from the original purchase date.