PowerMadd Star Series 14252 Mounting Kit for ATVs & Motorcycles User Manual

Page 2

Page 2:

LEFT / CLUTCH SIDE BRACKET

Right side view of ATV, bracket

is positioned under brake lever

and angles toward center.

NOTE: On most ATVs you will have to move the clutch (or brake) perch
over to create a gap between the perch and grip/control assembly to mount
the bracket. On some models the bracket may work on the other side of the
perch.

STEP 4: Slide the other steel strap on to the handlebar in between the
clutch perch and the grip. Any wires should go outside the strap and
bracket.

STEP 5: Attach the second bracket to the strap as you did in STEPS 2 & 3.

HAND GUARD MOUNTING

STEP 6: The four pictures below show the options for mounting the hand
guard to the bracket. These options allow you to move the guard right or left
depending on the position you prefer. Hold the hand guards up to the mounted brackets to decide which
mounting option to use. Then follow the instructions below for the option you have chosen.

When mounting the handguard to the bracket, make sure the no-spin spacer is positioned so that the pin goes
into the back hole of the bracket and the bolt goes through the front hole. Also make sure the no-spin spacer is
positioned so that its tabs go over one of the handguard tabs as in the Option photos below.

Option

Option 1 & 2 - RECOMMENDED: The strongest mounting option is to have the bracket and no-spin spacer
inside the handguard tabs. Thread the M6 x 45mm hex head bolt through the handguard tab, the no-spin spacer
and bracket, and then the other tab. Thread the lock nut onto the bolt and tighten using 10mm wrenches.

Option 3 & 4: Position the no-spin spacer on the bracket and handguard tab. Thread the M6 x 65mm hex head
bolt through the bracket, no-spin spacer and handguard tab. Insert the long spacer in between the handguard
tabs and continue to thread the bolt through the long spacer and the other handguard tab. Thread the lock nut
onto the bolt and tighten using 10mm wrenches.

STEP 7: Adjust both handguards to the desired up/down position by spinning the bracket on the handlebar.
Once in position, use a 10mm wrench to tighten the M6 x 25mm hex head bolt both brackets. DO NOT over
tighten the mounts, you want them tight enough that they won’t move if you land hard or hit a big bump, but
you don’t want them so tight that they won’t rotate if you were to crash.

STEP 8: All fasteners may need to be retightened after the first ride. Check the tightness of the bracket
and guard before each ride.

One Year “No Questions Asked” Warranty

POWERMADD warrants this product from breaking for any reason, no questions asked, for one year. Just send the
broken part back to POWERMADD along with a copy of your sales receipt with date of purchase and a replacement part
will be sent to you. POWERMADD shall not be liable for damage or injury caused by defective materials or
workmanship. After the one year from purchase POWERMADD warrants this product to be free from defects in material
and workmanship under use for the purpose it was intended. POWERMADD may elect to repair or replace this product,
but is the sole judge of any defects in their product. This warranty does not cover any labor costs to remove or reinstall
this product and is effect for one year from original purchase date.

PP5067 Rev D

1-800-435-6881 www.powermadd.com